Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 410 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL TANKINSTALLATION
2004 Oldsmobile Bravada AWD
Fuel Tank: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Bonneville, 2003 Buick Park Avenue, and 2003 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
- Position and support the fuel tank with the aid of an assistant. Install the fuel tank straps. Install the fuel tank strap bolts. Tighten the fuel tank strap bolts to TORQUE SPECIFICATIONS . Connect the fuel sender electrical connector.
- Install the fuel sender electrical harness into the retainers. Install the fuel and EVAP retainer to the frame. Connect the EVAP pipe to the EVAP canister. Connect the fuel feed pipe and the fuel return pipe. Install the rear suspension support assembly. See appropriate REAR article in SUSPENSION. Connect the fuel filler hose to the fuel filler pipe. Tighten the clamp to specification.
- Install the filler pipe opening cover. Lower the vehicle. Add fuel to the fuel tank. Install the fuel tank filler pipe cap. Connect the negative battery cable. Perform the following procedure in order to inspect for leaks. Turn ON the ignition switch for 2 seconds. Turn OFF the ignition switch for 10 seconds. Turn ON the ignition switch. Inspect for fuel leaks. Install the fuel injector sight shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.