SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 410 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL FILLER TUBEINSTALLATION
2004 Oldsmobile Bravada AWD

Fuel Filler Tube: Installation

2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Bonneville, 2003 Buick Park Avenue, and 2003 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel tank if previously removed. See FUEL TANK . Install the fuel filler tube into the fuel filler hose. Position the fuel filler tube for best fit and alignment then secure the fuel filler tube hose clamp.
  2. Tighten the hose clamp to specification. See TORQUE SPECIFICATIONS . Install the bolt to the fuel filler tube ground wire. Tighten the bolt to specification. Install the fuel filler tube cover. Lower the vehicle. Install the sealing ring around the fuel filler tube. Add fuel to the fuel tank. Inspect for fuel leaks. Install the fuel filler cap and close the fuel filler door.
Fig 1: Removing/Installing Fuel Filler Tube
G00158360Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.