SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 400 (ENGINE CONTROLS - REMOVAL & INSTALLATION)PROGRAMMINGPROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS10-MINUTE LEARN PROCEDURE
2004 Oldsmobile Bravada AWD

10-Minute Learn Procedure

2004 Oldsmobile Bravada AWDSECTION 10-Minute Learn Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect Tech 2 scan tool to vehicle.
  2. Select "Request Information" under "Service Programming".
  3. Disconnect Tech 2 scan tool from vehicle and connect it to a Techline(R) terminal.
  4. On Techline(R) terminal, select "Theft Module Re-Learn" under "Service Programming".
  5. Disconnect scan tool from the Techline(R) terminal and connect it to vehicle.
  6. Turn ignition on, with engine off.
  7. Select "VTD Re-Learn" under "Service Programming".
  8. Attempt to start engine, then release the key to ON position, vehicle will not start.
  9. Observe the SECURITY indicator light. After about 10 minutes the indicator light will turn off. The vehicle is now ready to relearn the Passlock(tm) Sensor Data Code and/or password on the next ignition switch transition from off to crank.
  10. Turn ignition off and wait 5 seconds.
  11. Start engine. Vehicle has now learned the password.
  12. With Tech 2 scan tool, clear any DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 2.2L VUE article or CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 3.0L VUE article.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.