Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 400 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSPRIMARY FUEL PUMP MODULEREMOVAL
2004 Oldsmobile Bravada AWD
Primary Fuel Pump Module: Removal
2004 Oldsmobile Bravada AWDSECTION Removal
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Remove fuel tank. See FUEL TANK . The primary fuel pump module is the fuel pump that is mounted closest to the fuel tank fill pipe fitting on the fuel tank. See Figure . Disconnect fuel lines from primary fuel pump module.
- Disconnect EVAP vent line from primary fuel pump module. Disconnect electrical connector from primary fuel pump module. Using Fuel Tank Lock Ring Remover/Installer (SA9156E), remove fuel pump module retaining ring. See Figure . A 1/2" breaker bar (approximately 18" long) will easily loosen and remove the lock ring.
- To prevent bending of the sending unit float arm during removal, lift the pump module up slightly to disengage the orientation tabs in the tank and rotate the module 45 degrees. Remove the fuel pump from fuel tank. Always replace fuel pump module to tank seal ring whenever assembly is removed.
- Discard fuel pump module-to-tank seal. If sending unit is not being replaced as well, remove fuel level sender from fuel pump module. See FUEL LEVEL SENDER UNIT & FLOAT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.