Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wheel Speed Signal Module Conditioner Module: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install wheel speed conditioner module by inserting module into connector. Make sure module is fully seated. Tape module to harness at point where connector lies. Install front console left trim panel retainer screws and push pin.
- Install steering column filler panel by aligning retention clips with corresponding slots in retainer and snapping into place. Install retainer screws.
- Install front console center trim panel by aligning retention clips with corresponding slots in retainer and snapping into place. Place transaxle in neutral.
- Install shifter bezel by aligning retention clips with corresponding slots in retainer and snapping into place. Move driver's front seat all the way forward. Slide floor console to proper position and install retainer screws.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.