Section 396 (Engine Controls Self-Diagnostics - 3.1L Engine): Programming: Notes

2004 Oldsmobile Bravada AWDSECTION Notes
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix, 2003 Chevrolet Malibu, and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: DO NOT program an existing PCM with the identical software/calibration package. This procedure is not a short cut to correct a driveability condition. This is an ineffective repair. A PCM should only be programmed when a service procedure instructs you to replace the PCM. The service part PCM does not contain operating software or calibrations or General Motors Corporation releases an updated software/calibration package.

After replacing Powertrain Control Module (PCM) or if program needs to be updated, refer to latest Techline® information on PCM reprogramming. PCM can only be programmed using Tech 2® and Techline® terminal, or by using a personal computer equipped with the current service programming system software installed.

Ensure that the following conditions are met before programming a control module:

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.