Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 390 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL SENDER ACCESS PANELREMOVAL
2004 Oldsmobile Bravada AWD
Fuel Sender Access Panel: Removal
2004 Oldsmobile Bravada AWDSECTION Removal
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
- Open the rear compartment lid. Remove the rear compartment convenience net. The type of retainers used for sill plate are the push on, screw off type. It is very important to follow this procedure or wasteful destruction of the screws will happen. Remove the convenience net retainers retaining the rear compartment sill plate to the vehicle. See Figure.
- Lift the rear compartment sill plate to disengage the clips from the sill. Remove the rear compartment sill plate from the vehicle. Remove the spare tire. Remove the convenience net retainers retaining the rear compartment trim panel to the floor. See Figure.
- Remove the rear compartment trim panel. Remove the push in retainer retaining the right-side rear compartment trim panel to the vehicle. See Figure. Remove the right-side rear compartment trim panel from the vehicle. Remove the fuel sender access panel bolts. See Figure. Remove the fuel sender access panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.