Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (ENGINE CONTROLS - REMOVAL & INSTALLATION)MISCELLANEOUSACCELERATOR CONTROLS CABLEREMOVAL
2004 Oldsmobile Bravada AWD
Accelerator Controls Cable: Removal
2004 Oldsmobile Bravada AWDSECTION Removal
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the accelerator cable shield, if equipped. Disconnect the accelerator cable from the throttle body lever. Disconnect the accelerator cable from the accelerator cable bracket.
- Remove the push-in retainers from the Insulator Panel (IP) insulator to instrument panel. Remove the press-on retainers from the IP insulator to dash mat. Unsnap the IP courtesy lamp from the IP insulator. Remove the IP insulator from the instrument panel.
- Disconnect the accelerator cable from the accelerator pedal. Squeeze the accelerator cable cover tangs and push the accelerator cable through the bulkhead. Remove the accelerator cable from the vehicle. Note the cable routing for aid in installation. See Figure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.