Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accelerator Controls Cable Bracket: Installation
Position the accelerator cable bracket on the throttle body. Install the accelerator cable bracket nut and bolts. Tighten the bolts/nut in sequence to specification. See Fig 3 . See TORQUE SPECIFICATIONS . Install the wire harness into the retainer. Install the air cleaner intake duct. Connect the accelerator controls cable to the accelerator cable bracket. Connect the accelerator controls cable cross slug to the throttle body lever. Connect the cruise control cable to the throttle lever and accelerator bracket, if applicable.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.