SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (ENGINE CONTROLS - REMOVAL & INSTALLATION)IGNITION SYSTEMSSPARK PLUG WIRESINSTALLATION
2004 Oldsmobile Bravada AWD

Spark Plug Wires: Installation

2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the spark plug wires to the engine. Install the spark plug wires to the ignition coils. See Figure . Install the spark plug wires (1, 3, and 5) to bank 2 spark plugs. Install the spark plug wires to the retaining clips.
  2. Return the engine to the proper position. Remove the engine tilter strap from the engine. Swing the engine mount struts in position. Install the engine mount strut bolts and tighten bolts to specification. See TORQUE SPECIFICATIONS  .
  3. Install the spark plug wires (2, 4, and 6) to bank 1 spark plugs. Install the spark plug wires to the retaining clips.
Fig 1: Spark Plug Wire Routing (Bank 1)
G00217071Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.