Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 376 (ENGINE CONTROLS - REMOVAL & INSTALLATION, OVERHAUL)TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Torque Specifications
2004 Oldsmobile Bravada AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||||
|---|---|---|---|---|---|---|
| Accelerator Pedal Mounting Bolts | 15 (20) | |||||
| AIR Check Valve-To-AIR Pipe | 17 (23) | |||||
| AIR Pipe-To-Exhaust Manifold | 15 (20) | |||||
| Camshaft Position Sensor Bolt | 18 (25) | |||||
| Crankshaft Position Sensor | 18 (25) | |||||
| Engine Coolant Temperature Sensor | 15 (20) | |||||
| Fuel Tank Shield Bolts/Nuts | ||||||
| Bolt | 18 (25) | |||||
| Nut | (1) | |||||
| Fuel Tank Strap Bolts | 18 (25) | |||||
| Knock Sensor | 15 (20) | |||||
| Muffler Bolts | 37 (50) | |||||
| Oxygen Sensor | 30 (41) | |||||
| Rear Stabilizer Shaft Bracket Bolts | 49 (65) | |||||
| Rear Stabilizer Shaft Bracket Nuts | 70 (95) | |||||
| Spark Plug | (2) | |||||
| Starter Mounting Bolt | 37 (50) | |||||
| Wheel Lug Nuts | 100 (140) | |||||
| INCH Lbs. (N.m) | ||||||
| AIR Pump Bolt | 80 (9.0) | |||||
| EVAP Canister Bracket Bolt | 62 (7.0) | |||||
| Fuel Fill & Vent Pipe Bolt | 22 (3.0) | |||||
| Fuel Fill Hose Clamp | 35 (4.0) | |||||
| Fuel Fill Pipe Ground Strap Bolt | 71 (8.0) | |||||
| Fuel Filter/Pressure Regulator Bracket Nut | 44 (5.0) | |||||
| Fuel Rail Bolt | 89 (10.0) | |||||
| Fuel Sender Assembly Bolts | 62 (7.0) | |||||
| Fuel Tank Crossover Hose Clamp | 35 (4.0) | |||||
| Ignition Coil Mounting Bolt | 106 (12.0) | |||||
| Ignition Coil Harness Connector Bolt | 106 (12.0) | |||||
| PCM | ||||||
| Retaining Bolt | 17 (2.0) | |||||
| Connector Bolt | 71 (8.0) | |||||
| PCV Heat Exchange Cable Nut | 106 (12.0) | |||||
| PCV Valve Pipe Strap Nut (LS1 Engine) | ||||||
| Throttle Actuator Control Module Bolt | 17 (2.0) | |||||
| Throttle Body Bolts | 89 (10.0) | |||||
| Vehicle Speed Sensor | 89 (10.0) | |||||
| Wheelhouse Filler Panel Bolt | 17 (2.0) | |||||
|
||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.