Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P1209: Fuel Injector Control Module PWM Output Signal Failure: Description
The Fuel Injector Control Module (FICM) monitors the CNG fuel injector circuits. The CNG fuel injector circuit status and internal FICM diagnostic data, is communicated to the Powertrain Control Module (PCM) by a Pulse Width Modulated (PWM) circuit. This DTC sets when the FICM diagnostic output PWM signal is not received by the PCM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.