Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 32 (HVAC SYSTEMS - MANUAL)TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Torque Specifications
2004 Oldsmobile Bravada AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| A/C Compressor Bolt | 37 (50) | |
| Refrigerant Hoses | ||
| Accumulator-to-Evaporator Tube | 12(16) | |
| Auxiliary Hose-To-Compressor Fitting | 33 (45) | |
| Auxiliary Evaporator Tube-To-Evaporator Hose Fitting | 35 (48) | |
| Compressor Tube-To-Accumulator Fitting | 35 (48) | |
| Compressor Suction/Discharge Tube Assembly-To-Compressor Bolt | 33 (45) | |
| Compressor Discharge Tube-To-Condenser Fitting | 21 (28) | |
| Evaporator Tube-To-Condenser Fitting | 14 (19) | |
| Condenser Mounting Nut | 21 (28) | |
| Evaporator Inlet Tube-To-Evaporator Fitting | 14 (19) | |
| INCH Lbs. (N.m) | ||
| A/C Low Pressure Switch | 53 (6) | |
| A/C Pressure Relief Valve | 80 (9) | |
| Accumulator Bracket Screw | 53 (6) | |
| Blower Resistor Screw | 18 (2) | |
| Condenser Bolt | 89 (10) | |
| Evaporator Screws | 53 (6) | |
| Heater Case Screws/Nuts | ||
| Auxiliary | 17 (2) | |
| Main | 53 (6) | |
| HVAC Control | 35 (4) | |
| Mode Actuators Screws | 17 (2) | |
| Refrigerant Filter Nuts | 133 (15) | |
| Vacuum Tank Screws | 17 (2) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.