Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 287 (POWER SUN ROOF)REPAIR INSTRUCTIONSPOWER SUNROOF MODULE REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD
Removal Procedure
2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Position the sunroof in the fully closed position.
- Remove the headliner. Refer to HEADLINER REPLACEMENT .
- Disconnect the sunroof harness from the body harness at the right rear pillar.
- Disconnect the front drain hose connections from the sunroof housing.
- Disconnect the rear drain hose connections from the sunroof housing.
- Remove the 4 sunroof module bracket to side rail bolts.
- Remove the 6 sunroof module to roof bolts.
- Remove the sunroof module at the actuator bracket bolt (center rear).
Important: Use two white nylon locator pins in order to correctly position the sunroof module and temporarily hold the module in place.
- Squeeze the locator pins and pull down on the sunroof module to disengage the two locator/retainers.
- Remove the sunroof module from the vehicle through the door opening.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.