Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 277 (BODY CONTROL MODULES)SELF-DIAGNOSTIC SYSTEMVARIABLE EFFORT STEERING DIAGNOSTIC SYSTEM CHECK
2004 Oldsmobile Bravada AWD
Variable Effort Steering Diagnostic System Check
2004 Oldsmobile Bravada AWDSECTION Variable Effort Steering Diagnostic System Check
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Connect scan tool to Data Link Connector (DLC). DLC is located below driver side of instrument panel, near steering column. If scan tool powers up, go to next step. If scan tool does not power up, perform TEST A: SCAN TOOL DOES NOT POWER UP under SYSTEM TESTS.
- Start engine. Using scan tool, attempt to communicate with Electronic Brake Control Module (EBCM). If scan tool communicates with EBCM, go to next step. If scan tool does not communicate with EBCM, perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS.
- Using scan tool, select DISPLAY DTCs for magnasteer. If scan tool does not display any DTCs for Dynamic Rear Proportioning (DRP)/Anti-Lock Brake System (ABS)/Traction Control System (TCS)/Vehicle Stability Enhancement System (VSES) (if equipped), go to next step. If scan tool displays any DTCs for DRP/ABS/TCS/VSES (if equipped), perform appropriate test. See appropriate ANTI-LOCK article in BRAKES.
- Using scan tool, select DISPLAY DTC for magnasteer. If scan tool displays DTCs C1241, perform appropriate test. See appropriate ELECTRONIC article in ELECTRONIC STEERING. If scan tool does displays any other DTCs, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.