Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 277 (BODY CONTROL MODULES)SELF-DIAGNOSTIC SYSTEMTHEFT DETERRENT DIAGNOSTIC SYSTEM CHECK
2004 Oldsmobile Bravada AWD
Theft Deterrent Diagnostic System Check
2004 Oldsmobile Bravada AWDSECTION Theft Deterrent Diagnostic System Check
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Connect scan tool to Data Link Connector (DLC). DLC is located below driver side of instrument panel, near steering column. If scan tool powers up, go to next step. If scan tool does not power up, perform TEST A: SCAN TOOL DOES NOT POWER UP under SYSTEM TESTS.
- Turn ignition switch to RUN position. Using scan tool, attempt to communicate with Driver Door Module (DDM), Dash Integration Module (DIM), Instrument Panel Cluster (IPC), Powertrain Control Module (PCM), Remote Control Door Lock Receiver (RCDLR), Rear Integration Module (RIM) and Theft Deterrent Control (TDC) module. If scan tool communicates with DDM, DIM, IPC, PCM, RCDLR, RIM and TDC module, go to next step. If scan tool does not communicate with DDM, DIM, IPC, PCM, RCDLR, RIM and TDC module, perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS.
- Using scan tool, access CLASS 2 POWER MODE. Cycle ignition switch through all positions while observing ignition switch power mode parameter. If ignition switch parameter matches ignition switch positions, go to next step. If ignition switch parameter does not match ignition switch positions, perform TEST C: POWER MODE MISMATCH under SYSTEM TESTS.
- Using scan tool, select DISPLAY DTCs for DDM, DIM, IPC, PCM, RCDLR, RIM and TDC module. If scan tool displays any DTCs, go to next step. If scan tool does not display any DTCs, repair theft deterrent system by symptom. See ANTI-THEFT SYSTEMS - AURORA article.
- If scan tool does not display any DTCs which begin with "U", go to next step. If scan tool displays any DTCs which begin with "U", perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS.
- Perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
CAUTION:
Engine may start. Turn ignition switch to OFF position as soon as you have observed crank power mode.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.