Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 277 (BODY CONTROL MODULES)SELF-DIAGNOSTIC SYSTEMAUDIBLE WARNINGS DIAGNOSTIC SYSTEM CHECK
2004 Oldsmobile Bravada AWD
Audible Warnings Diagnostic System Check
2004 Oldsmobile Bravada AWDSECTION Audible Warnings Diagnostic System Check
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Connect scan tool to Data Link Connector (DLC). DLC is located below driver side of instrument panel, near steering column. If scan tool powers up, go to next step. If scan tool does not power up, perform TEST A: SCAN TOOL DOES NOT POWER UP under SYSTEM TESTS.
- Turn ignition switch to RUN position. Using scan tool, attempt to communicate with Driver Door Module (DDM), Dash Integration Module (DIM), Instrument Panel Cluster (IPC), Instrument Panel Module (IPM) and Sensing and Diagnostic Module (SDM). If scan tool communicate with DDM, DIM, IPC, IPM and SDM, go to next step. If scan tool does not communicate with DDM, DIM, IPC, IPM and SDM, perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS.
- Using scan tool, select DTCs function for DIM, IPC, IPM and SDM. If scan tool displays any DTCs for DIM, IPC, IPM and SDM, go to next step. If scan tool does not display any DTCs for DIM, IPC, IPM and SDM, repair instrument panel by symptom. See INSTRUMENT PANELS - AURORA article.
- If scan tool does not display any DTCs which begin with "U", go to next step. If scan tool displays any DTCs which begin with "U", perform TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS.
- If scan tool does not display DTCs B1000, B1004, B1007, B1009, B1010, B1390 or B1422, go to next step. If scan tool displays DTCs B1000, B1004, B1007, B1009, B1010, B1390 or B1422, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
- If scan tool does not display DTCs B1327, B1513, B1514, P0560, P0562, P0563, P0615, P0620, P0621 or P0622, perform appropriate test. See ANALOG INSTRUMENT PANELS - AURORA article. If scan tool displays DTCs B1327, B1513, B1514, P0560, P0562, P0563, P0615, P0620, P0621, or P0622, perform appropriate test. See DIAGNOSTIC TESTS in GENERATORS & REGULATORS - AURORA article in ELECTRICAL.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.