Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
The Powertrain Control Module (PCM) supplies a 5-volt reference and a low reference circuit to both the Throttle Position (TP) sensor and the Manifold Absolute Pressure (MAP) sensor. The TP sensor sends a voltage signal back to the PCM relative to the throttle plate opening and the MAP sensor sends a voltage signal back to the PCM relative to the intake manifold pressure. The PCM can detect if the TP sensor or the MAP sensor are out of range by comparing the two values against the high and low limits and engine speed defined within the engine calibration. If the TP or MAP is not within the expected limits of the engine calibration, DTC P0105 is set.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.