Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 267 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL TANKINSTALLATION
2004 Oldsmobile Bravada AWD
Fuel Tank: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fuel sender assembly to the fuel tank. See FUEL SENDER ASSEMBLY .
- With the aid of an assistant, raise the fuel tank to the vehicle.
- Install the fuel tank retaining straps. Tighten the strap bolts to specification. See TORQUE SPECIFICATIONS .
- Connect the wiring harness into the multiway rear body connector.
- Connect the EVAP vapor pipe to the EVAP canister.
- Connect the fuel filler hose to the fuel tank. Tighten the fuel filler hose clamp to specification. See TORQUE SPECIFICATIONS .
- Install the rubber exhaust hangers.
- Install the exhaust heat shield. Tighten the exhaust shield bolt/nuts to specification. See TORQUE SPECIFICATIONS .
- Connect the fuel return pipe and fuel filter quick-connect fittings.
- Lower the vehicle.
- Refill the fuel tank.
- Install the fuel filler cap.
- Connect the negative battery cable. Tighten to specification. See TORQUE SPECIFICATIONS .
- Inspect for leaks by using the following procedure.
- Turn ignition switch to RUN position, with the engine OFF for 2 seconds.
- Turn ignition switch to OFF position for 10 seconds.
- Turn ignition switch to RUN position, with the engine OFF.
- Check for fuel leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.