Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 267 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL SENDER ASSEMBLYINSTALLATION
2004 Oldsmobile Bravada AWD
Fuel Sender Assembly: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fuel level sensor to the fuel sender assembly. See FUEL LEVEL SENSOR .
- Install the NEW seal on the fuel tank. See Figure .
- Align the fuel pipes parallel with the mark on the fuel tank.
- Slowly apply pressure to the top of the spring loaded sender until the sender aligns flush with the retainer on tank.
- Install the retaining ring using the Fuel Sender Lock Nut Wrench.
- Connect the wiring harness to the fuel sender and the FTP sensor.
- Install the fuel tank. See FUEL TANK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.