Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 218 (AUTOMATIC TRANSMISSION SERVICING - (AWD))REMOVAL & INSTALLATIONOVERDRIVE SWITCHINSTALLATION
2004 Oldsmobile Bravada AWD
Overdrive Switch: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the OVERDRIVE switch wires into manual selector knob.
- Snap the OVERDRIVE switch into the manual selector knob.
- Install the OVERDRIVE wires through the manual selector lever sleeve, then secure the sleeve with the lower screw. See Figure .
- Install the manual selector knob onto manual selector assembly, then install the shift button. See Figure .
- Fully seat the manual selector knob on the assembly, then tighten the 2 screws. See Figure .
- Install the 2 white OVERDRIVE switch wires into the OVERDRIVE switch/manual selector illumination lamp electrical connector (2). See Figure .
- Hook the 2 white OVERDRIVE switch wires onto the clip (1) on the manual selector base, then secure with a push clip.
- Install the OVERDRIVE switch/manual selector illumination lamp electrical connector (2) into the manual selector assembly.
- Install the manual selector assembly into vehicle. See MANUAL SELECTOR .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.