Component Locations

2004 Oldsmobile Bravada AWDSECTION Component Locations
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 GMC Savana Special, 2001 GMC Savana Camper Special, 2001 GMC Savana, 2001 Chevrolet RV Cutaway, and 2001 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see Fig 1 -Fig 6 .
COMPONENT LOCATIONS

Component Location
Electronic Brake Control Module On Left Frame Rail, Near Center Of Vehicle
Engine Coolant Temperature Gauge Sensor Center Front Of Engine, Near Thermostat
Engine Oil Pressure Gauge Sensor (1) Top Rear Of Engine
Fuel Tank Level Sender In Fuel Tank
Fuel Pump In Fuel Tank
Fuel Sender Buffer Module On Inner Knee bolster, Below Right Side Of Instrument Panel
Inflatable Restraint Sensing And Diagnostic Module Under Left Front Seat
In-Line Connector C301 In Engine Harness, In-Line To Fuel Pump Harness On Left Frame Rail, Near EBCM
Low Engine Coolant Level Indicator Module Under Left Side Of Instrument Panel
Low Engine Coolant Level Indicator Sensor Front Of Engine Compartment, Under Engine Coolant Recovery Tank
Multifunction Alarm Module Under Left Side Of Instrument Panel
Passlock(tm) Module Below Center Of Instrument Panel
Powertrain Control Module (4.3L, 5.0L & 8.1L) In Engine Compartment On Left Front Fender
Powertrain Control Module (6.5L) Behind Center Of Instrument Panel
Vehicle Speed Sensor (4L60-E) Right Rear Of Transmission
Vehicle Speed Sensor (4L80-E) On Left Side Of Transmission
Vehicle Speed Sensor Buffer Below Left Side Of Instrument Panel, Near Steering Column
Water-In-Fuel Sensor (Diesel) On Left Side Frame Rail, Near Center Of Vehicle
(1) Engine oil pressure gauge sensor may also be referred to as engine oil pressure gauge sender.
Fig 1: Locating Data Link Connector
G00062256Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.