SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2054 (COMPONENT CONNECTOR END VIEWS - (5 OF 5))SERIAL DATA GATEWAY (SDG) MODULE X1 (HP5)
2004 Oldsmobile Bravada AWD

Serial Data Gateway (SDG) Module X1 (HP5)

2004 Oldsmobile Bravada AWDSECTION Serial Data Gateway (SDG) Module X1 (HP5)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Serial Data Gateway (SDG) Module X1 (HP5) Connector End View
GM1715223Courtesy of GENERAL MOTORS CORP.
Serial Data Gateway (SDG) Module X1 (HP5)

Pin Wire Circuit Function
1 0.5 D-BU 3424 APM Wake-Up Signal
2 0.5 TN 3425 Wake Up Signal
3-10 - - Not Used
11 0.5 L-BU 6106 High Speed GMLAN Serial Data (-) (2)
12 0.5 L-BU 6106 High Speed GMLAN Serial Data (-) (2)
13 0.5 D-BU 6105 High Speed GMLAN Serial Data (+) (2)
14 0.5 D-BU 6105 High Speed GMLAN Serial Data (+) (2)
15 0.5 TN 2501 High Speed GMLAN Serial Data Bus -
16 0.5 TN 2501 High Speed GMLAN Serial Data Bus -
17 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus +
18 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus +
19 0.35 D-GN 5060 Low Speed GMLAN Serial Data
20 - - Not Used
Connector Part Information 
  • OEM: 15126711
  • Service: See Catalog
  • Description: 20-Way F 0.64 Series (BK)
Terminal Part Information 
  • Terminal/Tray: 7116-4618-02/14
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: J-38125-215A/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.