Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2051 (COMPONENT CONNECTOR END VIEWS - (2 OF 5))ELECTRONIC BRAKE CONTROL MODULE (EBCM) (HP5)
2004 Oldsmobile Bravada AWD
Electronic Brake Control Module (EBCM) (HP5)
2004 Oldsmobile Bravada AWDSECTION Electronic Brake Control Module (EBCM) (HP5)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Electronic Brake Control Module (EBCM) (HP5)
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| 1 | 3 RD/BK | 42 | Battery Positive Voltage |
| 2 | 0.5 BN | 882 | Right Rear Wheel Speed Sensor Signal |
| 3 | 0.5 GY/BK | 7128 | Wheel Speed Sensor Supply Voltage Right Rear |
| 4 | 0.5 GY/BK | 7127 | Wheel Speed Sensor Supply Voltage Left Rear |
| 5 | 0.5 TN | 884 | Left Rear Wheel Speed Sensor Signal |
| 6 | 0.5 D-GN | 872 | Right Front Wheel Speed Sensor Signal |
| 7 | 0.35 YE | 6046 | Steering Angle Sensor - Phase A |
| 8 | 0.35 TN | 6048 | Steering Angle Sensor - Index |
| 9 | 0.5 L-BU | 3334 | Brake Master Cylinder Piston Position Sensor Signal |
| 10 | - | - | Not Used |
| 11 | 0.5 WH | 17 | Brake Applied Signal |
| 12 | 0.35 | 5986 | Serial Data Communication Enable |
| 13 | 5 BK/WH | 51 | Ground |
| 14 | 0.5 PK | 339 | Ignition Voltage |
| 15 | 0.5 OG/BK | 6045 | Steering Angle Sensor Low Reference |
| 16 | 0.35 L-GN | 6043 | Steering Angle Sensor Signal |
| 17 | 0.5 GY/WH | 7065 | 5-Volt Reference |
| 18 | 0.5 TN | 948 | Ignition Voltage |
| 19 | 0.5 GY | 6044 | Steering Angle Sensor 5-Volt Reference |
| 20 | 0.5 D-BU | 6047 | Steering Angle Sensor - Phase B |
| 21 | 0.5 L-BU | 6106 | High Speed GMLAN Serial Data (-) (2) |
| 22 | 0.5 L-BU | 6106 | High Speed GMLAN Serial Data (-) (2) |
| 23 | 0.5 TN | 2501 | High Speed GMLAN Serial Data Bus- |
| 24 | 0.5 TN | 2501 | High Speed GMLAN Serial Data Bus- |
| 25 | 3 RD/WH | 240 | Battery Positive Voltage |
| 26 | - | - | Not Used |
| 27 | 0.5 BN | 5382 | Low Reference |
| 28 | 0.5 GY/WH | 7064 | Wheel Speed Sensor Supply Voltage Left Front |
| 29 | 0.5 L-BU | 830 | Left Front Wheel Speed Sensor Signal |
| 30 | 0.5 TN | 950 | Yaw Rate and Lateral Acceleration Sensor Ground |
| 31 | 0.5 GY | 3335 | 5-Volt Reference |
| 32 | 0.5 D-GN/WH | 817 | Vehicle Speed Signal (U3U) |
| 33 | 0.5 D-BU | 6105 | High Speed GMLAN Serial Data (+) (2) |
| 34 | 0.5 D-BU | 6105 | High Speed GMLAN Serial Data (+) (2) |
| 35 | 0.5 PU | 3333 | Brake Master Cylinder Piston Position Sensor Signal |
| 36 | 0.5 TN/BK | 2500 | High Speed GMLAN Serial Data Bus+ |
| 37 | 0.5 TN/BK | 2500 | High Speed GMLAN Serial Data Bus+ |
| 38 | 5 BK/WH | 51 | Ground |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.