Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1997 (REAR DRIVE AXLE)REPAIR INSTRUCTIONSREAR DIFFERENTIAL CLUTCH CONTROL MODULE REPLACEMENT

2004 Oldsmobile Bravada AWD

Rear Differential Clutch Control Module Replacement

2004 Oldsmobile Bravada AWDSECTION Rear Differential Clutch Control Module Replacement

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Differential Clutch Control Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the exhaust system. Refer to Exhaust Muffler Replacement (LAT or LE5) or Exhaust Muffler Replacement (LZ4) or Exhaust Muffler Replacement (LY7) or Exhaust Muffler Replacement (LCS) . Remove the rear differential assembly. Refer to Differential Replacement .
1	Clutch Drum Control Module Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 15 N.m (133 lb in)
2	Clutch Drum Control Module Connector
3	Clutch Drum Control Module Procedure: Program the control module. Refer to Control Module References .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.