Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Steering Control Module Scan Tool Information (with HP5)
2004 Oldsmobile Bravada AWDSECTION Power Steering Control Module Scan Tool Information (with HP5)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Power Steering Control Module Scan Tool Data Parameters
| Parameter | System State | Expected Value | Definition |
|---|---|---|---|
| Operating Conditions: Ignition ON | |||
| Calculated System Temperature | - | Varies | This displays °C (°F). This is the calculated temperature of the power steering system. |
| Battery Voltage | - | Varies | This displays battery voltage. |
| PSCM SPS Calibration Status | - | Varies | The scan tool displays if PCSM calibration procedure has been completed or not. |
| PSCM Center Procedure | - | Varies | The scan tool displays if PCSM centering procedure has been completed or not. |
| Steering Shaft Torque | - | Varies | This displays N-m. This is the calculated force of the steering shaft, as monitored by the power steering control module. |
| Steering Wheel Position | - | Varies | This displays °. This is the state of the steering wheel position. |
| Vehicle Speed | - | Varies | This displays the actual vehicle speed. |
| Vehicle Speed Status | - | Valid | The scan tool displays Valid or Invalid. This is the current state of the vehicle speed. |
Power Steering Control Module Scan Tool Output Controls
| Scan Tool Output Control | Description |
|---|---|
| Steering Pos./Torque Sensor Cal. | This is used to calibrate the steering position/torque sensor. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.