Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fuel level sensor cover (3) to the fuel level sensor (2).
- Ensure that the fuel level sensor retainers (1) are fully engaged to the cover.
- Position the fuel level sensor to the fuel tank fuel pump module and slide the sensor down into position.
- Connect the fuel level sensor electrical connector (1) to the fuel tank fuel pump module cover.
- Install the fuel level sensor wiring behind the retaining features (1) molded into the fuel tank fuel pump module reservoir.
- Install the fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.