SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1975 (DATA COMMUNICATION SYSTEM)REPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENT
2004 Oldsmobile Bravada AWD

Body Control Module Replacement

2004 Oldsmobile Bravada AWDSECTION Body Control Module Replacement
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module
GM1870266Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the accessory trim plate. Refer to Front Floor Console Accessory Trim Plate Replacement
  2. Remove the Transmission Control. Refer to Transmission Control Replacement
1 Body Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Reprogram the module if replaced. Refer to Control Module References .

Tip:  Push tab to release the body control module from the bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.