Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Mode Actuator
    GM1646796Courtesy of GENERAL MOTORS CORP.
  1. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement .
  2. Remove the communication interface module, if equipped. Refer to Communication Interface Module Replacement .
  3. Disconnect the electrical connector from the mode actuator.
  4. Remove the mode actuator screws from the evaporator case assembly.
  5. Remove the mode actuator from the evaporator case assembly.
  6. Fig 2: View Of Mode Cam Bracket, Mode Cam & Mode Cam Levers
    GM1646798Courtesy of GENERAL MOTORS CORP.
  7. Remove the screws retaining the mode cam bracket (1) to the evaporator case assembly.
  8. Remove the mode cam bracket (1) from the evaporator case assembly.
  9. Remove the mode cam (2) and the mode cam levers (3) from the evaporator case assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.