Inside Rearview Mirror Replacement

2004 Oldsmobile Bravada AWDSECTION Inside Rearview Mirror Replacement
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Replacing Inside Rearview Mirror
GM2000287Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Inside Rearview Mirror
CAUTION: Refer to Fastener Caution .

Procedure

  1. Remove the inside rearview mirror cover, if equipped
  2. Disconnect the electrical connector, if equipped.
  3. Adjust the mirror to the full upward position.
  4. Loosen the set screw located at the base of the mirror.
  5. Slide the mirror upward off of the rearview mirror button.
  6. Refer to Control Module References for programming and setup information.

Tighten:  2 N.m (18 lb in)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.