Scan Tool Data List

2004 Oldsmobile Bravada AWDSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The electronic brake control module (EBCM) Scan Tool Data Lists contain all the antilock brake system related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The column, "Data List," indicates the location of the parameter within the scan tool menu selections.

Use the EBCM Scan Tool Data Lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all the diagnostic procedures with the antilock brake system (ABS) Diagnostic Starting Point. Use the EBCM Scan Tool Data Lists only after the following is determined:

  • There is no published DTC procedure nor published symptom procedure for the customer concern.

    OR

  • The DTC or symptom diagnostic procedure indicated by the diagnostic system check does not resolve the customer concern.

The Typical Data Values are obtained from a properly operating vehicle under the conditions specified in the first row of the Scan Tool Data List table. Comparison of the parameter values from the suspect vehicle with the Typical Data Values may reveal the source of the customer concern.

The ID Information menu is located on the EBCM main screen.

EBCM Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Ignition is ON, engine OFF, and vehicle is stationary
Battery Voltage ABS Volts 11.5 Volts
Brake Switch ABS Applied/Released Released
Left Front Wheel Speed ABS/TCS km/h or mph 0
Left Rear Wheel Speed ABS/TCS km/h or mph 0
LF Inlet Valve Solenoid ABS Active/Inactive Inactive
LF Outlet Valve Solenoid ABS Active/Inactive Inactive
LR Inlet Valve Solenoid ABS Active/Inactive Inactive
LR Outlet Valve Solenoid ABS Active/Inactive Inactive
LF Valve Solenoid TCS Apply/Released Released
LR Valve Solenoid TCS Apply/Released Released
Pump Motor Relay Command ABS/TCS On/Off Off
Pump Motor Relay Feedback ABS/TCS On/Off Off
RF Inlet Valve Solenoid ABS Active/Inactive Inactive
RF Outlet Valve Solenoid ABS Active/Inactive Inactive
RR Inlet Valve Solenoid ABS Active/Inactive Inactive
RR Outlet Valve Solenoid ABS Active/Inactive Inactive
Right Front Wheel Speed ABS/TCS km/h or mph 0
Right Rear Wheel Speed ABS/TCS km/h or mph 0
RF Valve Solenoid TCS Apply/Released Released
RR Valve Solenoid TCS Apply/Released Released
Traction Switch BCM On/Off On
Traction Switch LED BCM On/Off On
Valve Relay ABS/TCS On/Off On
Valve Relay State ABS/TCS On/Off On
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.