Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1855 (COMPONENT LOCATIONS AND CONNECTOR END VIEWS)POWER AND GROUNDING COMPONENT VIEWS
2004 Oldsmobile Bravada AWD
Power and Grounding Component Views
2004 Oldsmobile Bravada AWDSECTION Power and Grounding Component Views
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Powertrain Control Module (PCM) Bracket |
| 2 | C105 |
| 3 | C102 (L66) |
| 4 | Body Harness |
| 5 | Fuse Block-Underhood |
| 6 | C106 |
| 7 | Body Harness |
| 8 | C108 |
| Callout | Component Name |
|---|---|
| 1 | Fuse Block - Underhood |
| 2 | Heater Core Pump |
| 3 | Park Neutral Position (PNP) Switch |
| 4 | Transmission Control Module (TCM) |
| 5 | Battery - 12V |
| 6 | Electronic Control Module (ECM) |
| 7 | Fuse Block - Underhood - Auxiliary |
| Callout | Component Name |
|---|---|
| 1 | Instrument Panel |
| 2 | Wheel Well - RR |
| 3 | Generator Battery - 36V |
| 4 | Generator Battery - 36V |
| 5 | Generator Battery Vent Fan |
| 6 | Generator Battery Disconnect Control Module |
| 7 | Generator Battery Service Disconnect Switch |
| Callout | Component Name |
|---|---|
| 1 | C106 |
| 2 | Fuse Block - Underhood |
| 3 | C122 |
| 4 | Daytime Running Lamp (DRL) Resistor |
| 5 | Cooling Fan Resistor |
| 6 | Splice Pack SP101 |
| 7 | G101 |
| 8 | S111 |
| 9 | Hood Ajar Switch Connector |
| Callout | Component Name |
|---|---|
| 1 | Fuse Block - Underhood |
| 2 | Battery Positive Cables (12V) |
| 3 | Positive Battery Voltage |
| 4 | Battery - 12V |
| 5 | Negative Battery Cables |
| 6 | G103 |
| 7 | Fuse Block - Underhood - Auxiliary |
| 8 | G105 |
| 9 | Positive Battery Voltage |
| 10 | Engine Block |
| Callout | Component Name |
|---|---|
| 1 | Fuse Block - Underhood C2 |
| 2 | C102 Engine Harness to Body Harness |
| 3 | Park Neutral Position (PNP) Switch |
| 4 | C100 Engine Harness to Transmission Harness |
| 5 | G105 |
| 6 | C150 Engine to Fuel Injector Harness |
| 7 | G107 |
| Callout | Component Name |
|---|---|
| 1 | Manual Transmission (MG3) |
| 2 | G105 |
| 3 | G107 |
| Callout | Component Name |
|---|---|
| 1 | Fuel Injector 6 |
| 2 | Ignition Coil 6 |
| 3 | Fuel Injector 5 |
| 4 | Ignition Coil 5 |
| 5 | Ignition Coil 4 |
| 6 | Fuel Injector 4 |
| 7 | Camshaft Position (CMP) Sensor |
| 8 | Knock Sensor (KS) |
| 9 | G109 |
| 10 | Ignition Coil 1 |
| 11 | Fuel Injector 1 |
| 12 | Ignition Coil 2 |
| 13 | Fuel Injector 2 |
| 14 | Ignition Coil 3 |
| 15 | Fuel Injector 3 |
| Callout | Component Name |
|---|---|
| 1 | G203 |
| 2 | Fuse Block - I/P |
| Callout | Component Name |
|---|---|
| 1 | Body Harness |
| 2 | G205/Splice Pack (SP205) (JM4) |
| 3 | C200 |
| 4 | S501 |
| 5 | S500 |
| 6 | S204 |
| Callout | Component Name |
|---|---|
| 1 | Instrument Panel (I/P) Trim |
| 2 | Body Harness |
| 3 | C306 (AG1/KA1) |
| 4 | C305 (AG1/KA1) |
| 5 | G301 |
| 6 | Splice Pack SP301 |
| 7 | S304 |
| 8 | C204 (U2K) |
| 9 | S209 |
| 10 | Front Windshield |
| Callout | Component Name |
|---|---|
| 1 | C400 |
| 2 | Tail Lamp - LR |
| 3 | C300 |
| 4 | Splice Pack SP401 |
| 5 | G401 |
| 6 | Door Jamb Switch - LR |
| 7 | Left C Pillar |
| 8 | C309 |
| 9 | Seat Belt Pretensioner - Left |
| 10 | Door Panel - LR |
| 11 | C700 |
| 12 | Liftgate |
| Callout | Component Name |
|---|---|
| 1 | Seat Belt Pretensioner - Right |
| 2 | C310 |
| 3 | G403 |
| 4 | Splice Pack SP403 |
| 5 | C401 |
| 6 | Tail Lamp - RR |
| 7 | Cellular/Navigational/Digital Antenna |
| 8 | Liftgate |
| 9 | C403 |
| 10 | C402 |
| 11 | C800 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.