Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1835 (HYDRAULIC BRAKE SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL OUTPUT CONTROLS
2004 Oldsmobile Bravada AWD
Scan Tool Output Controls
2004 Oldsmobile Bravada AWDSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Automated Bleed Procedure | - | Used in order to bleed the ABS hydraulics. Refer to Antilock Brake System Automated Bleed Procedure . |
| ABS Warning Lamp | - | Commands the ABS indicator ON and OFF |
| Left Front Solenoid | - | Commands the solenoid ON and OFF |
| Left Rear Solenoid | - | Commands the solenoid ON and OFF |
| Pump Motor | - | Commands the pump motor ON and OFF |
| LF Inlet Solenoid | Solenoid Test | Commands the solenoid ON and OFF |
| LF Outlet Solenoid | Solenoid Test | Commands the solenoid ON and OFF |
| LR Inlet Solenoid | Solenoid Test | Commands the solenoid ON and OFF |
| LR Outlet Solenoid | Solenoid Test | Commands the solenoid ON and OFF |
| LF Master Cylinder Isolation Solenoid | Solenoid Test | Commands the solenoid ON and OFF |
| LF Prime Solenoid | Solenoid Test | Commands the solenoid ON and OFF |
| TCS On/Off test | - | Commands the traction control system ON and OFF. Performs the same function as the traction control switch. |
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Brake Hold Sol. 1 | Starter/Generator Control Module | Used in order to command the hill hold solenoid valve (HHV) On and Off. |
| Brake Hold Sol. 2 | Starter/Generator Control Module | Used in order to command the hill hold solenoid valve (HHV) On and Off. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.