Turn Signal Multifunction Switch Replacement

2004 Oldsmobile Bravada AWDSECTION Turn Signal Multifunction Switch Replacement
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Column Trim Covers Replacement
GM1829731Courtesy of GENERAL MOTORS CORP.
Turn Signal Multifunction Switch Replacement

Callout Component Name
Preliminary Procedure: 
Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
1 Multifunction, Turn Signal Switch
Tip: 
  • Disconnect the electrical connector.
  • Depress the locking tabs to remove the multifunction, turn signal switch.
  • During installation, make sure both locking tabs are seated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.