SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1812 (FRAME AND UNDERBODY)REPAIR INSTRUCTIONSASSIST STEP REPLACEMENT (Z-71)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Avalanche, 2003 Cadillac Escalade EXT, and 2003 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rocker panel molding bracket (4) to the vehicle.
  2. Install the rivets (3) that secure the rocker panel molding bracket (4) to the vehicle.
  3. Install the assist step brackets (5) to the vehicle.
    NOTE: Refer to FASTENER NOTICE in GM VEHICLES CAUTIONS & NOTICES .
  4. Install the 5 retaining bolts (1) to the inner side of the rocker panel.

    Tighten 

    Tighten the bolts (1) to 29 N.m (21 lb ft).

  5. Install the 5 retaining bolts (2) to the inner side of the rocker panel.

    Tighten 

    Tighten the bolts (1) to 10 N.m (89 lb in).

    Fig 1: Installing Retaining Bolts To Inner Side Of Rocker Panel
    G03384600Courtesy of GENERAL MOTORS CORP.
  6. Install the 5 stud plates (1) to the 5 assist step brackets (2).
    Fig 2: Installing Stud Plates To Assist Step Brackets
    G03384601Courtesy of GENERAL MOTORS CORP.
  7. Install the rivets (1) that secure the assist step brackets to the rocker panel.
  8. Install the rocker panel molding. Refer to MOLDING REPLACEMENT - ROCKER PANEL (Z-71) or MOLDING REPLACEMENT - ROCKER PANEL (UTILITY) in Exterior Trim.
    Fig 3: Installing Rivets Securing Assist Step Brackets To Rocker Panel
    G03384602Courtesy of GENERAL MOTORS CORP.
  9. With the aid of an assistant, install the assist step to the vehicle.
  10. Install the spacers and the nuts (1).

    Tighten 

    Tighten the bolts (1) to 29 N.m (21 lb ft).

    Fig 4: Installing Spacers And Nuts
    G03384603Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.