Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Frame Reference Point Description
Reference points are locations on a vehicle which correspond to specific measuring points. Use the reference points when checking the vehicle structure.
Dimension charts may use the center of a hole, bolt head, or nut, etc. as a reference point. A description and location chart will tell you how and where the measurements should be taken. The most accurate reference point is a gauge hole or a control hole used by the assembly plant in order to control tolerances when the vehicle was built. Refer to FRAME CONTROL HOLE DESCRIPTION on for more information about control holes.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.