HVAC Component Views

2004 Oldsmobile Bravada AWDSECTION HVAC Component Views
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Body Front End HVAC Components
GM747711Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Ambient Air Temperature Sensor
Fig 2: Identifying A/C Refrigerant Pressure Sensor, Six Cylinder Engine Components
GM797101Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 A/C Refrigerant Pressure Sensor
2 A/C Compressor
Fig 3: Identifying Six Cylinder Engine, Left Side Components
GM747710Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 A/C Compressor Clutch Assembly
2 A/C Compressor
Fig 4: Upper Right Side of the Engine - Front (5.3L)
GM1494485Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Engine Harness
2 A/C Refrigerant Pressure Sensor
Fig 5: Lower Right Side of the Engine - Front (5.3L)
GM1494487Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 A/C Compressor
2 A/C Compressor Clutch Assembly
3 Engine Harness
Fig 6: RR of the Engine Compartment
GM1494489Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 A/C Low Pressure Switch
2 Forward Lamp Harness
3 A/C Accumulator
4 Coolant Bypass Valve
Fig 7: Dash Panel
GM1486698Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Speaker - LF I/P (UQA)
2 Ambient Light Sensor (CJ3)/Ambient Light/Sunload Sensor Assembly (CJ2)
3 Speaker - RF I/P (UQA)
Fig 8: Identifying Instrument Panel Carrier HVAC Components - Center Section
GM747731Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Air Temperature Sensor - Lower Left
Fig 9: Instrument Panel Carrier - Air Duct
GM1495151Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Air Temperature Sensor - Upper Left
2 Air Temperature Sensor - Upper Right
Fig 10: Identifying Instrument Panel Carrier Components
GM799702Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Blower Motor
2 I/P Center Support
3 Blower Motor Resistor Assembly (CJ3)/ Blower Motor Control Module(CJ2)
4 Air Temperature Actuator - Left
Fig 11: Identifying Instrument Panel Carrier Components, Left & Right
GM747718Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Air Temperature Actuator-Right
2 Air Temperature Actuator-Left
3 Defrost Actuator
4 Mode Actuator
Fig 12: Identifying Instrument Panel Carrier-Right Side HVAC Components
GM747716Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Air Temperature Sensor - Lower Right
Fig 13: Identifying Instrument Panel Carrier, Cowl Side
GM747719Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Recirculation Actuator
Fig 14: Identifying Front Auxiliary Blower Motor Switch
GM826160Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Lower Console
2 Blower Motor Switch - Front Auxiliary
Fig 15: Identifying Instrument Panel HVAC Component, Center
GM747722Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 HVAC Control Module
Fig 16: Lower Console
GM1551512Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Lower Console
2 HVAC Control Module - Auxiliary
3 Auxiliary Power Outlet - Console
4 Console Mode Actuator - Auxiliary
5 C309
6 C307
Fig 17: Identifying B-Pillar HVAC Components, Left
GM747723Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Air Temperature Sensor Assembly - Inside
Fig 18: Blower Motor Control Processor Components - Auxiliary
GM1208964Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Body Rear Opening
2 Blower Motor Control Processor-Auxiliary
3 Rear Evaporator and Heater Core
Fig 19: Body Harness, C401 Routing View
GM872310Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Mode Actuator - Auxiliary
2 Blower Motor - Auxiliary
3 Air Temperature Actuator - Auxiliary
4 C401
5 Blower Motor Fuse - Auxiliary
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.