Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1754 (THEFT DETERRENT SYSTEM)REPAIR INSTRUCTIONSADDING KEYS
2004 Oldsmobile Bravada AWD
Adding Keys
2004 Oldsmobile Bravada AWDSECTION Adding Keys
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- You may add up to 10 additional master keys or valet keys using this procedure if 2 learned master keys are available. If 2 learned master keys are not available the 10 minute relearn procedure must be performed. Refer to Programming Theft Deterrent System Components .
- If more than one valet key is to be learned, immediately precede each valet key by 2 learned master keys.
- This procedure adds keys only. The procedure does not erase previously learned keys.
- The keys to be learned must duplicate the mechanical cut of the current key.
- With a previously learned master key, turn ON the ignition with the engine OFF.
- Turn OFF the ignition and remove the key.
- Within 10 seconds insert a second previously learned master key. Turn ON the ignition with the engine OFF.
- Turn OFF the ignition and remove the key.
- Within 10 seconds insert the key to be learned. Turn ON the ignition with the engine OFF. The vehicle has now learned the new key.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.