Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1754 (THEFT DETERRENT SYSTEM)COMPONENT LOCATORTHEFT DETERRENT SYSTEM CONNECTORS
2004 Oldsmobile Bravada AWD
Theft Deterrent System Connectors
2004 Oldsmobile Bravada AWDSECTION Theft Deterrent System Connectors
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Inclination Sensor
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | OG | 2740 | Battery Positive Voltage |
| 2 | - | - | Not Used |
| 3 | PK | 5363 | Inclination Sensor Signal |
| 4 | L-BU | 5362 | Inclination Sensor Low Reference |
Theft Deterrent Alarm
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | PK | 239 | Ignition 1 Voltage |
| 2 | OG | 1140 | Battery Positive Voltage |
| 3 | TN/BK | 5168 | Power Sender Enable Signal |
| 4 | BK | 2450 | Ground |
Theft Deterrent Control Module
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | OG | 1140 | Battery Positive Voltage |
| B | PK | 1020 | Ignition 0 Voltage |
| C | TN | 751 | Ground |
| D | WH | 710 | Class 2 Serial Data |
| E | WH | 1132 | Class 2 Serial Data |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.