Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Midgate Window Run Channels
    GM1243189Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate window run channels to the midgate.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Loosely install the screws retaining the midgate window run channels to the midgate.
  4. Install the wiring harness retainer to the window run channel bracket.
  5. Install the midgate window. Refer to Window Replacement - Midgate .
  6. Finish tightening the screws retaining the window run channels to the midgate.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  7. Install the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.