SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1753 (BODY REAR END)REPAIR INSTRUCTIONSWEDGE REPLACEMENT - MIDGATEINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Midgate Wedge
    GM1204230Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate wedge (2) to the vehicle.
  2. Install the screw (1) retaining the wedge to the body.

    Tighten:  Tighten the screw only until the wedge cannot rock up and down, but can slide fore and aft.

  3. Slide the midgate wedge as far forward as possible.
  4. Close the midgate assembly to set the wedge adjustment.
  5. Open the midgate.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Fully tighten the midgate wedge screw.

    Tighten:  Tighten the midgate wedge screw to 10 N.m (89 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.