SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1753 (BODY REAR END)REPAIR INSTRUCTIONSWEATHERSTRIP REPLACEMENT - MIDGATEINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Midgate Weatherstrip
    GM1204237Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate weatherstrip to the vehicle.
  2. Locate and install the midgate weatherstrip mold to the body by installing the push-pins (1).
  3. Align the paint dots (2) on the weatherstrip to the sheet metal joints of the window channel.
  4. Press the weatherstrip into the midgate window channel beginning at the alignment locations (2), and working around the window channel.
  5. Press the weatherstrip onto the lower pinch-weld flange, working around the lower midgate opening.
    6. Fig 2: Locating Midgate Sliding Hinge Filler Panel Retainers
    GM1236624Courtesy of GENERAL MOTORS CORP.
  6. Slide the retaining clips (1) down on the sliding hinge panel to release the sliding hinge panel.
  7. Close the midgate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.