Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1753 (BODY REAR END)REPAIR INSTRUCTIONSMIDGATE PANEL REPLACEMENT - OUTERINSTALLATION PROCEDURE

2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Midgate Outer Panel From Midgate

Courtesy of GENERAL MOTORS CORP.

Install the midgate outer panel to the midgate assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts retaining the midgate outer panel to the midgate structure.
Tighten: Tighten the outer panel nuts to 5 N.m (44 lb in).
Install the midgate sliding hinge filler panel. Refer to Hinge Filler Panel Replacement - Midgate Sliding .
Install the midgate window run channels. Refer to Window Channel Replacement - Midgate .
Install the midgate window regulator. Refer to Window Regulator Replacement - Midgate .
Install the midgate window. Refer to Window Replacement - Midgate .
Install the midgate window sealing strip. Refer to Sealing Strip Replacement - Midgate Window Outer .
Install the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
Install the midgate assembly to the vehicle. Refer to Midgate Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.