Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1730 (STEERING WHEEL & STEERING COLUMN)COMPONENT LOCATORSTEERING COLUMN DISASSEMBLED VIEW
2004 Oldsmobile Bravada AWD
Steering Column Disassembled View
2004 Oldsmobile Bravada AWDSECTION Steering Column Disassembled View
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Upper Trim Cover |
| 2 | Lower Trim Cover |
| 3 | Steering Column Closeout Trim Cover |
| 4 | Retaining Ring |
| 5 | SIR Coil |
| 6 | Wave Washer |
| 7 | Bearing Retainer |
| 8 | Cam Orientation Plate |
| 9 | Shaft Lock Shield Assembly |
| 10 | Turn Signal Cancel Cam Assembly |
| 11 | Upper Bearing Spring |
| 12 | Upper Bearing Inner Race Seat |
| 13 | Wire Harness Strap |
| 14 | Inner Race |
| 15 | Signal Switch Housing |
| 16 | Pan Head Tapping Screws |
| 17 | Turn Signal and Multifunction Switch Assembly |
| 18 | Steering Column Tilt Head Assembly |
| 19 | Pan Head Tapping Screws |
| 20 | TORX® Head Screw |
| 21 | Ignition Lock Cylinder Case |
| 22 | Theft Deterrent Control Module |
| 23 | Ignition Switch Assembly |
| 24 | Spring Guide |
| 25 | Tilt Spring |
| 26 | Theft Deterrent Control Module Electric Park Lock |
| 27 | Steering Shaft Assembly |
| 28 | Tilt Bumper |
| 29 | Pivot Pins |
| 30 | Steering Column Support Assembly |
| 31 | Coil Wire Harness Assembly |
| 32 | Coil Wire Harness Assembly (Export) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.