SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1717 (FRAME & UNDERBODY)REPAIR INSTRUCTIONSTRANSMISSION SUPPORT REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD

Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the fuel tank shield. Refer to Fuel Tank Shield Replacement (Trailblazer, Envoy)  or Fuel Tank Shield Replacement (Trailblazer EXT, Envoy XL) .
  3. If vehicle is a short wheel base (Trailblazer, Envoy, Bravada), remove the evaporative emission (EVAP) canister from its mounting bracket. Do not disconnect the canister lines. Refer to EVAP CANISTER in Engine Controls.
  4. Support the transmission with a transmission jack.
    5. Fig 1: View Of Transmission Mount To Transmission Support
    GM744176Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission mount to the transmission support retaining nuts.
    6. Fig 2: Removing Lower Transmission Support To Frame Mounting Bolts
    GM745746Courtesy of GENERAL MOTORS CORP.
  6. Remove the lower transmission support to the frame mounting bolts.
    7. Fig 3: Removing Upper Transmission Support To Frame Mounting Bolts
    GM752138Courtesy of GENERAL MOTORS CORP.
  7. Remove the upper transmission support to the frame mounting bolts.
  8. Remove the transmission support from the frame.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.