Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1714 (REAR DRIVE AXLE)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada AWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Clutch Cover M8 Bolts | 26 N.m | 19 lb ft |
| Drain Plug | 30 N.m | 22 lb in |
| Fill Plug | 35 N.m | 26 lb ft |
| Input Flange 3/4 x 20 Nut | 203 N.m | 150 lb ft |
| Prop Guard | 24 N.m | 18 lb ft |
| Propeller Shaft-to-Drive Shaft Flange M10 Bolts | 70 N.m | 52 lb ft |
| Rear Bracket Bushing-to-Body M12 Bolts | 105 N.m | 77 lb ft |
| Rear Bracket M12 Bolts/Nuts | 105 N.m | 77 lb ft |
| Rear Cover M10 Bolts | 46 N.m | 34 lb ft |
| Rear Cover M8 Bolts | 26 N.m | 19 lb ft |
| Ring Gear M8 Bolts | 54 N.m | 40 lb ft |
| Side Bracket Bushing-to-Body M12 Bolts | 105 N.m | 77 lb ft |
| Vent Fitting | 24 N.m | 18 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.