SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1669 (HVAC SYSTEMS - MANUAL)REPAIR INSTRUCTIONSHVAC CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD

Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement in Instrument Panel, Gages and Console.
  2. Remove the I/P storage compartment. Refer to Storage Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
  3. Remove the center trim bezel. Refer to Trim Bezel Replacement - Center in Instrument Panel, Gages and Console.
    4. Fig 1: HVAC Control Module Connectors
    GM939709Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the temperature cable from the HVAC control module.
  5. Disconnect the blower switch from the HVAC control module.
  6. Disconnect the electrical connector from the HVAC control module.
  7. Disconnect the remaining electrical connectors from the center trim bezel.
    8. Fig 2: HVAC Control Module & Screws
    GM939703Courtesy of GENERAL MOTORS CORP.
  8. Remove the HVAC control module screws from the center trim bezel.
  9. Remove the HVAC control module from the center trim bezel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.