Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wiper transmission assembly to the vehicle.
- Connect the electrical connector to the wiper motor.
- Insert the wiper motor post into the slot in the plenum, push the transmission assembly forward to seat the post.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the bolts retaining the wiper transmission assembly to the vehicle.
Tighten: Tighten the wiper transmission assembly bolts to 8 N.m (71 lb in).
- Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT (ENVOY, TRAILBLAZER) in Body Front End.
- Install the windshield wiper arms. Refer to Wiper Arm Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.