Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1602 (BODY REAR END)REPAIR INSTRUCTIONSLIFT GATE CONTROL MODULE PROGRAMMING
2004 Oldsmobile Bravada AWD
Lift Gate Control Module Programming
2004 Oldsmobile Bravada AWDSECTION Lift Gate Control Module Programming
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- The liftgate module (LGM) must be programmed with the proper RPO configurations. The LGM stores the information regarding the vehicle options. If the LGM is not properly configured with the correct RPO codes the LGM will not control the features properly. Ensure that the following conditions exist in order to prepare for the LGM programming:
- The battery is fully charged.
- The ignition switch is in the RUN position.
- The DLC is accessible.
- Follow the instructions on the Techline Terminal and scan tool to program the LGM.
- If the LGM fails to accept the program, perform the following steps:
- Inspect all LGM connections.
- Verify that the Techline Terminal and scan tool have the latest software version.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.