Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear window lower molding. Refer to Molding Replacement-Rear Window Lower   . 
  2. Remove the trim panel. Refer to Trim Panel Replacement-Rear Quarter (Regular Cab)   or Trim Panel Replacement-Rear Quarter (Extended Cab)   or Trim Panel Replacement-Rear Quarter (Crew Cab)   . 
  3. Remove the carpet retainers.
  4. Remove the carpet from the vehicle.
    Fig 1: Rear Panel Carpet
    G01578037Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.